Testing valve springs
Valve springs can lose a lot of their strength over the years, as seen with this R25/3 valve spring: a new spring measures 16.6 kg, the old spring 10.1 kg, almost 40% lower. Lower spring tension usually causes no or minor problems on low revving engines, but it can lead to loss of power / misfiring on higher revving engines as a result of valve float The test device:
R50 – R69S Old and New style shifter mechanism
Comparison between the “old” and “new” version of the R50 – R69S shifter mechanism. Click following link for a comparison of the cam plates: Gearbox cam plate comparison
Fitting the correct distribution gear set
The number stamped in the crankcase (from -10 to +10) refers to the size of the crankshaft and camshaft gears installed by the BMW factory. After 60 – 70 years of service, the crankcase may have grown, which means that the original gear set may not be the optimal set anymore (0.01 to 0.02 mm play between the 2 gears). One way to determine the correct gear set number is to measure the c-t-c distance between the crankshaft and camshaft. This value must then be compared to the nominal c-t-c distance. This is impossible without very accurate measuring tools. The difference in
Read more »