Pistons aren’t round

An article that explains why pistons aren’t round. Click on piston to open it:

Side stands for EU and USA models

There is a clear length difference between the side stands for the R50 – R69S models and the R50US, R60US and R69US models (due to different configurations of the front fork) These are therefore not interchangeable.

Installation instructions 12V dynamo system VAPE

Click here for installation instructions 12V dynamo system VAPE: Dynamo System 70 80 499 0XX

BING jets

BING jets are stamped with numbers, such as 35, 40 (idle jets) and 110, 115, 120 etc (main jets). One would expect that these numbers refer to the diameter of the jet bore, however this is not the case. This is confimed by the company BING in Germany. A few examples of main jets measured with a wire / jet gauge: BING 44-051 main jet 130 = gauge 120 (= 1.2 mm) main jet 125 = gauge 110 (= 1.1 mm) main jet 120 = gauge 105 (= 1.05 mm) main jet 110 = gauge 95 (=0.95 mm)            
Read more »

Matra 282 tool

We mill 2 planes on the threaded bushing so that it is possible to use a 22 mm wrench on the threaded bushing. This is necessary in cases where (for instance) the crankshaft bearing is glued to the bearing journal, to prevent the threaded bushing from rotating while tightening the central bolt

Cylinder heads R50 – R69S: butterheads and LK heads

Very informatieve article by Duane Ausherman on “butterheads” and LK heads: http://www.w6rec.com/duane/bmw/head/

Brake levers with finger grooves

The brake levers with finger grooves (PN32722072252) currently available in the market, do not fit in the throttle housing of the R26, R27, R50 – R69S models. The hole for the lever screw is of few thenth of a millimeter off it’s original position: the lever gets blocked and cannot be “opened”. New brake levers that do not have this problem are only expected to become available by the end of 2017. Till then, the solution is to mill off +- 0.3 mm from the edges on both sides. After polishing, no traces of milling are visible anymore. This is what
Read more »

Exhaust pipes

Different exhaust pipes are available in the market, unfortunately not always an exact replica of the original pipes: the shape of the bends does not correspond with the original BMW exhaust pipes as can be seen on this picture. The 2 lower exhaust pipes are identical to the original pipes    some of these pipes follow a slightly different path than the original exhaust pipes. This causes a problem for the R67 – R67/3 models: in the horizontal section, they’re not running close enough to the frame, causing too little clearance between the brake pedal and the right-hand exhaust pipe, as
Read more »

Carburetor reconditioning

With hardly any new carburetors being produced by BING for the < 1969 BMW mono and twin motorcycles, it’s getting increasingly important to be able to repair and recondition the used original carburetors. Luckily, special parts and tools are available nowadays to restore the carburetors to a good working condition. A. Idle mix screw: very often, the M7 x 0.75 mm screw thread in the carburetor housing is worn out. There are 2 good solutions to this problem. 1. drill the threaded hole to 7.2 mm – cut M8 x 0.75 mm screw thread – install the idle mix screw with
Read more »